83
2-14-3. HC-54 Board
Preparation
1. Remove the handle upper cabinet assembly. (Refer to “2-14-1. Handle Upper Cabinet Assembly”.)
Procedure
1. Remove the screw (PTP2 x 5) and the two precision screws (P2 x 4), and then remove the handle bottom cover.
2. Remove the HC-54 board from the handle bottom cover.
3. Disconnect the flexible board from the connector (CN2402) on the HC-54 board.
4. Install the removed parts by reversing the steps of removal.
PTP2 x 5
Precision screws
(P2 x 4)
CN2402
Flexible board
HC-54 board
Handle bottom cover
To Next Page
Loading...