Note
The unit conforms to IEEE802.3bt Type 4 Class 8. For details about verified compatible PoE++ power delivery devices, contact your
dealer or Sony service representative.
The unit is compliant with soft authentication (LLDP), but it may be necessary to configure network devices (IEEE802.3bt compliant).
Do not connect a DC power cable to the DC IN connector when using PoE++ power delivery with soft authentication (LLDP) enabled.
If a DC power supply and PoE++ power delivery device are connected at the same time, power is supplied from the DC power supply.
When supplying power via PoE++, use a Category 5e or higher network cable.
Wait about 10 seconds after turning the unit on again when powered via PoE++.
When connecting via PoE++ power delivery, do not run wiring outdoors.
TP1001804475
5-065-326-11(1) Copyright 2024 Sony Corporation
When power is supplied by PoE++, initial authentication is performed during the interval until startup has finished.
To Next Page
Loading...
