Recording
movies
01
Recording
still
images
0
1 Turn the POWER switch [g
in
the
direction of the arrow until the
01
(Movie) lamp lights up.
1 Turn the POWER switch [g
in
the
direction of the arrow until the
0
(Still) lamp lights up.
~
_0
2 Press PHOTO
[E]
lightly to adjust
the focus
0 (a beep sounds),
then press it fully
0 (a shutter
click sounds).
!REel
1IlI!lIJ!
e
L.:-
:.:....J 0:00:14
130min]
[STBY]
+ [REC]
IIJI
eII8Om1n
To stop recording, press START/STOP
[E]
(or
~)
again. Flashing + Lights
up
111I11I1
appears beside 9 or D . When
11I11I11
disappears, the image has been
recorded.
2 Press START/STOP
[E]
(or
~).
.
~.
Tips
• For the recordable time and the number
of
recordable images, see pages
11,
24 and 74.
• You can record still images
duri~
movie
recording by pressing PHOTO
~
([Dual Reel.
p.32).
• A frame
is
shown on the detected face, and the
detected face image is optimized automatically
([FACE DETECTION],
p.
72).
• When a face
is
detected during movie recording,
[I
flashes and the detected face is stored
in
the
index. You can search for a desired scene by a
face image when playing back ([Face Index],
p.37).
• You can capture still images from recorded
movies (p. 51).
• You can switch the shooting mode by touching
~
(HOME)
[AJ
(or
~)
--+
_ (CAMERA)
--+
[MOVIE]
or
[PHOTO].
• The LCD screen
of
your camcorder can display
recording images across the entire screen (full
pixel display). However, this may cause slight
trimming
of
the top, bottom, right, and left
edges
of
images when played back on a TV
which is not compatible with full pixel display.
In this case, set [GUIDEFRAME] to [ON]
(p. 70), and record images using the outer frame
displayed on the screen as a guide.
30
To Next Page
