192
Resizer
Chapter 4 Keys
4
Set the parameters.
These settings are the same as those for crop of DME. For details, see
“Crop Settings” in Chapter 11 (Volume 2).
Note
If defocus is enabled, and in the <Defocus Mode> group you select Video/Key,
then the crop is disabled. If mosaic is enabled crop is disabled.
Applying a border to a key for which resizer is on
For example, to add the border for key 1 of the M/E-1 bank, use the following
procedure.
1
In the M/E-1 >Key1 >Processed Key menu, press [Resizer], turning it on.
This enables the resizer function.
2
Press [Border/Crop].
The Border/Crop menu appears.
3
Press [Border], turning it on.
This enables the adjustment of crop.
4
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
•SD format
•HD format
Knob Parameter Adjustment Setting Values
1 H Simultaneously adjust width of left
and right borders
0.00 to 4.00
2 V Simultaneously adjust width of top
and bottom borders
0.00 to 3.00 (4:3)
0.00 to 2.25 (16:9)
3 All Simultaneously adjust width of all
four borders
Value of H shown
5 Density Density of the borders 0.00 to 100.00
Knob Parameter Adjustment Setting Values
1 H Simultaneously adjust width of left
and right borders
0.00 to 12.00 (4:3)
0.00 to 16.00 (16:9)
To Next Page
Loading...
