343Color Corrector Functions
Chapter 9 Color Corrector
• Y lift correction: adjusting the curvature of the curve.
• Y dark correction: adjusting the position of the maximum point of the
curve.
It is also possible to mask part of the region to be corrected.
Applying luminance processing
1
In the CCR menu, press VF1 ‘CCR1’ and HF5 ‘Luminance Process.’
The Luminance Process menu appears.
2
In the <Luminance Process> group, press [Luminance Process], turning it
on.
3
In the <Mode> group, specify the adjustment mode.
Tint: add a specified color to the original video signal.
Color Modify: adjust the original video signal.
Y Modify: adjust the output levels of the input luminance signal.
When tint mode or color modify mode is selected, skip to step 4.
When Y modify mode is selected, adjust the following parameters.
Output signal
luminance level
Black balance adjustment
White balance adjustment
Input signal
luminance
level
Unadjusted signal
Input signal
luminance
level
Output signal luminance level
Y Dark
Adjusted signal
Y Lift
Knob Parameter Adjustment Setting values
1 White White balance adjustment 0.00 to 200.00
2 Black Black balance adjustment –100.00 to +100.00
To Next Page
Loading...
