50
Recording
Chapter 3 Recording and Playback
To check the status during recording
Press the DISPLAY button.
For details on each indication displayed, see
“
3
LCD display” (see page 18).
To stop recording
Press the STOP button.
Recording stops and this unit enters E-E
mode.
When you stop recording, video, audio and
subsidiary data from the start to end of the
recording are recorded as a single clip on an
SxS memory card.
For details on clips, see Chapter 4 “Clip
Operations” (page 53).
Recording shot marks
When you record shot marks for important
scenes as subsidiary data, you can access
the marked points easily on a Shot Mark
screen, which only displays scenes with
shot marks only. This increases editing
efficiency.
For the Shot Mark Screen, see “Displaying the
SHOT MARK screen” (page 63).
This unit allows you to record two types of
shot marks: shot mark 1 and shot mark 2.
Shot marks can be recorded as needed
during recording or can be added after
recording while checking the playback
pictures (see page 52).
To insert a shot mark during
recording
Use the IR remote commander.
1 Set “IR Remote” (see page 93) of the
OTHERS menu to “On” to activate the
IR remote commander.
2 Start recording and press the
SHOTMARK 1 or 2 button where you
wish to insert a shotmark.
A shot mark of the type corresponding
to the button you press is recorded.
1
2
T
ZOOM
PUSH SET
SHOTMARK
SUB CLIP
THUMBNAIL
PLAY/PAUSE
STOP
W
.>xu
PREV NEXT
SHOTMARK 1 button
SHOTMARK 2 button
To Next Page
Loading...
