Sony SLV-360 - Pinch Press Block Assembly, Elevator Gear (Fig. 3-6)

3-6. PINCH PRESS BLOCK ASSEMBLY,
ELEVATOR GEAR (Fig. 3-6)
1) Remove E ring © to pull out pinch press block assembly @.
2) Remove lid opener @ by pressing claw @ in the arrow ©
direction.
3) Pull out elevator gear @.
[Note on Mounting]
+ Apply grease FLOIL SG-055G (Jig Ref. No. J-12) to ¥
marked portions.
+ Be sure to match the phase @ between elevator gear @ and
press gear ©) on mounting elevator gear @.
® Ering
vy 1 drop
@ Pinch press block assembly
© Lid opener
3x1 drop
Fig. 3-6
@ Elevator
gear