Sony SLV-360 - Page 91

3-16. CAM MOTOR CHASSIS BLOCK ASSEM-
1)
2)
3)
4)
BLY, UPPER/LOWER COMMUNICATION
GEAR (Fig. 3-18)
Remove timing belt. (Refer to 3-3.)
Remove CAP brake assembly. (Refer to 3-4.)
Remove screws @ to remove cam motor chassis assembly
@.
Pull out upper/lower communication gear ©.
[Note on Mounting]
+ First, check main slider @ slides fully in the arrow @ direction.
+ Set rotary encoder switch position to “E” seen from the
window of cam motor chassis. (Fig. A)
+ Tighten screws @ in the order @ to @ to @ to ©.
Fig. A
@ Screws (3 x 8)
(Fig. B)
Arrow of cam motor chassis.
@ Screws (3 x 8)
@ Cam motor
chassis block
assembly
Abbreviations of rotary encorder
switch position are carved on
cam gear.
@ UPPER/LOWER
COMMUNICATION
GEAR
—26—
4} Carved on cam gear.