There
is
no
sound
from
one
of
the
front
speakers.
• Connect a pair
of
headphones to
the
PHONES jack to verify that sound
is
output from the headphones.
If
only
one
channel
is
output from the headphones, the
component may not
be
connected to the
receiver correctly. Check that all the cords
are
fully
inserted into
the
jacks
on
both
the
receiver
and
the
component.
If
both
channels
are
output from the headphones.
the front speaker may not
be
connected to
the
receiver correctly. Check the
connection
of
the front speaker which
is
not outputting any sound.
• Make
sure
you have connected both the L
or
R jack to
an
analog component
and
not
just to either the L or R jack. Use a
monaural-stereo cable (not supplied).
However, there
will
be
no sound from
the
center speaker when a sound ticld (Pro
Logic, etc.)
is
selected. When
the
center
speaker
is
not connected, sound
is
output
only
from the front left/right speakers.
There
is
no
sound
from
analog 2
channel sources.
• Check to make
sure
the
selected audio
(digital) input
jack
is not assigned to other
inputs in
"Input
Assign" in
the
Input menu
(page 100).
There
is
no
sound
from
digital
sources
(from COAXIAL
or
OPTICAL
input
jack).
• Check that
the
INPUT
MODE
is
not
set
to
"Analog"
(page 99).
• Check that
the
"2ch Analog
Direct"
is
not
being
used.
• Check to make
sure
the
selected audio
(digital) input
jack
is not assigned to other
inputs in
"Input
Assign" in the Input menu
(page 100).
140
GB
The source
sound
input
from
the HOMI
jack
is
not
output
from
an
amplifier
or
the
TV speaker
connected
to
the
receiver.
• Check that
the
component
is
connected
correctly to
the
HDMljack
for that
component.
• The sound is not output when you display
the receiver's menu
on
the
TV
monitor.
Press
AMP
MENU
to turn
ofT
the display.
• Depending
on
the playback component,
component may
need
to
be
setup. Refer to
the operating instructions supplied
with
the
each
component.
•
Be
sure
to
use
a connecting cable for the
HDMljack
con'esponding to high
speed
(an
HDMI
version I.:la, category 2 cable)
when you view images or listen to sound
during a DeepColor transmission.
The
left
and
right
sounds
are
unbalanced
or
reversed.
• Check that the speakers
and
components
are
connected correctly
and
securely.
• Adjust
the
balance parameters using the
Auto Calibration settings menu.
There
is
severe
hum
or
noise.
• Check that the speakers
and
components
are
connected securely.
• Check that the connecting cords are away
from a transformer
or
motor,
and
at
least
:I
meters (10 feet) away from a
TV
set
or
fluorescent light.
• Move your
TV
away from the audio
components.
• Make sure you have grounded the
,j.,
SIGNAL
GND
terminal (only when a
turntahle is connected).
• The plugs
and
jacks
are
dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There
is
no
sound,
or
only
a
very
low-
level
sound
is
heard
from
the
centerl
surround/surround
back
speakers.
• Select a "Cinema Studio
EX"
mode
(page 67).
To Next Page
Loading...
