Sony STR-DA5300ES - Page 141

The image of the COMPONENT VIDEO
OUT is corrupted.
o Video input signals other than 480p
component
are not received when signals
conNnued'----------~
141
GB
There is no sound from the component
connected to the DIGITAL MEDIA PORT
adapter.
• Adjust the volume of this receiver.
• The
DIGITAL MEDIA PORT adapter
and/or component is not connected
correctly. Turn
off the receiver, then
reconnect
the DIGITAL MEDIA PORT
adapter and/or component.
o Check the DIGITAL MEDIA PORT
adapter and/or component device to make
sure
it supports this receiver.
The MULTI CHANNEL DECODING lamp
does not light up
in blue.
• Check that the playback component is
connected
on a digital jack and the input is
selected properly
on this receiver.
• Check whether
the input source of the
software being played back corresponds to
the multi-channel format.
o Check whether the setup on the playback
component
is set to multi-channel sound.
o Check to make sure the selected audio
(digital) input
jack is not assigned to other
inputs in
"Input Assign" in the Input menu
(page 100).
o Adjust the speaker level (page 74).
o Make sure the center/surround speaker (s)
is (are)
set to either "SMALL" or
"LARGE" (page 74).
There is no sound from the surround
back speakers.
• Some discs have no Dolby Digital
Sun'ound EX tlag even though the
packages have Dolby Digital Surround
EX
logos. In this case, select "0 "in the "SB
Dec Mode" (page 71 ).
There is no sound from the sub woofer.
o Check that the sub woofer is connected
correctly
and securely.
• Make
sure you have turned on your
speaker.
• When all speakers
are set to "LARGE"
and "Neo:6 Cinema," or "Neo:6 Music" is
selected, there is no sound from the
sub
woofer.
The surround effect cannot be
obtained.
• Make sure the sound field function is on
(press
MOVIE or MUSIC).
o Sound lIelds do not function for signals
with a sampling frequency
of more than 48
kHz.
Dolby Digital or DTS multi-channel
sound is not reproduced.
o Check that the DVD, etc. you are playing
is recorded in
Dolby Digital or DTS
format.
• When connecting the
DVD player, etc., to
the digital input jacks of this receiver,
make sure
the setting for the digital audio
output
of the connected component is
available.
Recording cannot be carried out.
o Check that the components are connected
correctly (page 22).
o Select the source component using INPUT
SELECTOR (page 53).
Video
There is no picture or an unclear
picture appears on the TV screen or
monitor.
o Select the appropriate input on the receiver
(page 53).
•
Set your TV to the appropriate input mode.
• Move your
TV away from the audio
components.
• Assign
the component video input
correctly.
• The input signal should
be same as input
when you
are up-converting an input
signal with this receiver (page 34).
..
»
Q.
Q.
::;:
ci"
:::J
!!!..
:r
0'
3
III
-
c)"
:::J