Notes
•
The
auto calibration function does not work
if
headphones are connected.
• Cancel
MUTING
if
it
is set to on.
Optimizer microphone
1 Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2 Set up the optimizer
microphone.
Place the optimizer microphone
at
your
seating position. Usc a stool
or
tripod
so
that the
optimizer
microphone remains
at
the same height
as
your
ears. Orient the L
end
of
the optimizer microphone toward
the front left speaker
and
the R end
of
the
optimizer microphone toward the front
right speaker.
Note
When you position the
optimizer
microphone
at the
center
of
the two speakers. if the angle
between the two speakers is too narrow. the
optimizer
microphone cannot measure the left
and right speakers properly.
On setting up the active sub
woofer
• When a sub woofer is connected, turn on the
sub woofer and turn up the volume
beforehand. Turn the
MASTER
VOLUME
knoh to
just
before the mid-point.
•
If
you connect a sub woofer
with
the
crossover frequency function,
set
the value
to maximum.
•
If
you connect a sub woofer
with
an
auto
standby function,
set
it
to
off
(deactivated).
CUTOfFFRf.Q
(Cro._"'-q-.q,
Note
Depending on the characteristics
of
the sub
woofer
you are using. the setup distance value may be
further away from the actual position.
Using the receiver as a pre-
amplifier
You can
use
the auto calibration function when
you usc the receiver
as
a pre-amplifier.
In this
case,
the distance value shown on the
display may
diller
from the actual distance
value. However, there
will
be
no problems
even
if
you continue to
use
the receiver with
that value.
Performing
auto
calibration
The auto calihration function allows you to
measure the
following:
• Speaker connections")
• Polarity
of
speakers
• Speaker distanee
hl
• Speaker angle
hl
• Speaker size
hl
• Speaker level
• Frequency characteristies
ci
..
G>
CD
:;,
~
CQ
CJ)
-
III
::1
CD
Q.
continued--
_
47
GB
To Next Page
Loading...
