Message
list
after
auto
calibration
measurement
..
Display
Code 30
Code
31
Code
32
Code
:n
Code
34
Warning 40
Warning
41
Warning 42
Warning 43
Warning 44
Explanation
Headphones are connected. Remove the headphones and perform the auto calibration again.
SPEAKERS
(Ol-'I-'/A/B/A+B)
is
set
to
01-'1-'.
Set it to others and re-perfonn the measuremenl.
None
of
the speakers were detected. Make sure that the
optimizer
microphone is connected
properly and reperfonn the measurement.
If
the
optimizer
microphone is connected properly but the
error
code appears, the
optimizer
microphone cable may
be
damaged
or
improperly connected.
• None
of
the front speakers are connected or
only
one front speaker
is
connected.
• The
optimizer
microphone
is
not connected.
• Either the left
or
right surround speakers is not connected.
• Surround back speakers arc connected even though surround speakers are not connected.
Connect the surround speaker(s) to the
SURROUND
terminals.
• The surround back speaker
is
connected only to the
SURROUND
BACK
SPEAKERS
R
terminals. When you connect
only
one surround back speaker. connect it to the
SURROUND
BACK
SPEAKERS
L terminals.
Speakers
are
not placed in the proper position. Speakers
or
an
optimizer
microphone
on
the
right
or
left may
be
placed wrongly.
See"
I:
Installing speakers" (page
16)
and check the
speaker position.
The measurement
has
completed. However, the noise level is high.
You
may
be
able
to
perform the measurement properly
if
you
try
it again, even though the measurement cannol
be
performed in all environments.
Try
to perform the measurement in a quiet environment.
The sound input from the
optimizer
microphone is outside the acceptable range.
It
is louder
than the loudest sound that
can
be
measured. Try to perform the measurement when the
environment is quiet enough
10
allow
proper measurement.
The volume
of
the receiver
is
out
of
the acceptable range.
Try
to perform the measurement
when the environment is quiet enough to
allow
proper measurement.
The distance
and
position
of
a sub woofer cannot
be
detected.
Or
the angle
of
the speaker
position cannot
be
detected. This may
be
caused by noise.
Try
to perform the measurement
in a quiet environment.
Measurement
has
been
completed. However the speakers are not placed in the proper position
with
respect to each other.
Sec"
I:
Installing speakers" (page
16)
and check the relative
positions
of
the speakers.
G)
111
8=.
::::l
lQ
en
iii
...
-
111
Co
NO
WARNING
There
is
no warning information.
No
speakers arc connected.
-Code
31
1
Press
8,
then
follow
the instructions from step
I
of
"Performing
auto calibration."
-Code
32,33,34
1 When you
press
8,
"Retry'!"
appears.
2
Press
+1+ to select "Yes," then press
8.
3
Follow
the instructions from step 2
of
"Performing
auto calibration."
When you select "WRN CHECK"
If a
warning
on the
measurement
result is
present, detailed information is displayed.
Press
8)
to return to step 1 of
"Confirming/saving the measurement
results" (page 49).
continued------
51
GB
To Next Page
Loading...
