quality sound when you
do
not have a
center
speaker
connected.
Analog
downmix
works
when you set
"Ccnter
Mix"
to
"ON."
This
setting
is
also effective to input signals from
MULTI
CHANNEL
INPUT
jacks.
• Sur Back Assign
(Settings of the surround back
speaker(s»
•
OFF
If
you have not connected surround back
speakers, select
"OFF."
•
BI-AMP
If
you
connect
front speakers in a bi-
amplilier conliguration, select
"BI-AMP."
•
ZONE
2
If
you arc using thc surround back speakers
in
zone 2, select
"ZONE
2." When you select
"ZONE
2," the input to the
SUR
BACK
jacks
of
the MULTI
CHANNEL
INPUT
is
invalid.
Note
Set "'Sur Back Assign" to "OFF," then connect the
surround back speakers to this receiver when you
want to change the connection from a bi-amplifier
connection
or
a zone 2 connection to a surround
back speakers connection. Re-set up the speakers
after you connect the surround back speakers. Refer
to "Auto Calibration" (page 46)
or
"Manual Setup"
(page 74).
• Crossover Freq
(Speaker crossover frequency)
Lets you set the bass crossover frequency
of
speakers that has been set to
"SMALL"
in the
Speaker
menu. Measured speaker
crossover
frequency is set for
each
speaker
aftcr thc
auto
calibration.
The
adjusted value is set for
each
speaker
when you adjust the
speaker
crossover
frequency using
"Crossover
Freq"
after
the
auto calibration.
• Multi Ch SW Level
(Multi-channel sub woofer level)
Lets you increase the level
of
the MULTI
CHANNEL
INPUT
sub
wooferchannel signal
by
+I0 dB.
This
adjustment may be necessary
when connecting a
DVD
player to the MULTI
CHANNEL
INPUT
jacks.
The
sub woofer level from DVD players is 10
dB lower than that
of
Super
Audio
CD
players.
• D.Range Comp
(Dynamic range compressor)
Lcts you
compress
the dynamic range
of
the
sound track.
This
may
be
useful when you
want to watch movies at low volumes late at
night.
Dynamic
range compression is possible
with Dolby Digital sources only.
•
OFF
Thc
dynamic
range is not compressed.
•
STD
The
dynamic
range is compressed as
intended by the recording
engineer
.
•
MAX
The
dynamic
range is compressed
dramatically.
Tips
• Dynamic range compressor lets you compress the
dynamic range
of
the soundtrack based on the
dynamic range information included
in
the Dolby
Digital signal.
•
"STD"
is
the standard setting, but
it
only enacts
light compression. Therefore,
we
recommend
using the
"MAX"
selling. This greatly compresses
the dynamic range and lets you view movies late
at
night at low volumes. Unlike analog limiters, the
levels are predetermined and provide a very nalllral
compression.
• Distance Unit (Distance unit)
Lets you select the unit
of
measure for setting
distances.
• meter
The
distance
is
displayed in meters.
• feet
The
distance is displayed in feet.
..
To Next Page
Loading...
