SPI Lasers redPOWER QUBE - 12.1.2 System Zone Alarms; 12.1.3 Control Zone Alarms

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
114
Code
Description
8m18
Driver Negative Power Supply Failure
8m19
PLC Driver Output Fault
12.1.2 System Zone Alarms
Code
Description
1102
System configuration memory failure. Unknown configuration data loaded.
QUBE Fiber Laser will not operate. Factory configuration setup required.
1120
Serial communications failure
1123
Ethernet communications failure
1130
HPFL – Combiner base plate - High temperature
1131
High internal optics temperature
1133
HPFL – LCMS Cover Temperature
1160
Serial watchdog timeout
1162
Ethernet watchdog timeout
12.1.3 Control Zone Alarms
Code
Description
2101
Modulation frequency error – Frequency demand out of range
2102
Update error – Attempted parameter update failed
2103
Peak current demand error – Peak current demand out of range
2105
Ramp time error – Ramp timing out of range
12.1.4 Modulator Zone Alarms
Code
Description
3m02
QUBE FL Module fault
3m03
QUBE FL Module communications failure
3m04
QUBE FL Module communications failure