© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
The protective cap and protective tape should only be removed after the BDO is routed and
immediately before the optical connector is inserted into the process head. Remove the
protective cap slowly holding the optical connector downwards to avoid contamination settling
on the window.
Do not grease optical connectors
Keep the optical connector facing downwards when uncovered and not installed.
Do not touch the window
The optical connector must not be subjected to forces caused by dropping, impacting or
collision with heavy objects.
7.8.2 Optical connectors must be inspected, and cleaned if
necessary, before being replaced. See Section 13.3.
The PIPA-Q optical connector should be installed as follows:
Carefully route the BDO following the instructions given in Section 7.7.
Carefully clean any dust or debris away from the receiver of the of the process head,
collimating optics or adapter, taking care that nothing gets into the process head.
Position the process head so that the receiver for the optical connector is horizontal.
Remove the sealing plug from the receiver.
Figure 25 PIPA-Q with protective cap
Remove the protective cap, shown in Figure 25, from the optical connector. It can be
pulled straight off.
To Next Page
Loading...