© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
13.3 Cleaning Optics
The cleanliness of all optical surfaces is critically important. Contamination in the optical path
from environmental dirt or dust, or finger grease from incorrect handling must be avoided as
the contamination will be burned into the optical surface causing permanent damage. Before
being exposed to high power, connector end faces should be inspected, preferably with a
magnifying aid, and cleaned if any contamination is observed.
If the window on the BDO is damaged, or too dirty to clean, replacements are available to
order from SPI Lasers.
Table 18 Replacement Windows
14 Disposal
At end of life, this QUBE Fiber Laser should be separately collected from unsorted waste with
a view to meeting the recovery and recycling targets specified in the appropriate national
regulations implementing the WEEE Directive on waste electrical and electronic equipment
(WEEE) for a product of its class.
15 General Information
15.1 Trade Marks
The SPI Lasers logo, SPI, GTWave, redPOWER and redENERGY are trademarks
(registered or applied for) of SPI Lasers in at least one of the United States of America, the
United Kingdom, the European Community and China, and in various other territories
throughout the world. All other trademarks are the property of their registered owners.
15.2 Licensing
This QUBE Fiber Laser carries no licence by IMRA America, Inc. for pulsed operation less
than 100ps.
15.3 Software
Any software forming part of this equipment should be used only for the purpose for which it
was supplied by SPI Lasers. No changes, modifications or copies (except for producing a
necessary back-up copy) shall be undertaken by the User.
To Next Page
Loading...