© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
7.6 Electrical Connections
7.6.1 General
CAUTION: This QUBE Fiber Laser is designed to BS EN 60204-
1:2006+A1:2009 and must be grounded for safety and to comply
with regional electrical codes.
Failure to do so may result in electric shock and incorrect operation
of the QUBE Fiber Laser.
For safe operation of this QUBE Fiber Laser the electrical connections given in the following
sections need to be made. All electrical connections should use cables of the shortest
practical length.
For safety, the QUBE Fiber Laser must be connected to an external protective grounding
system before any other electrical connections are made. The QUBE Fiber Laser is not ‘hot
pluggable’: all electrical connectors should be mated and secured in place before power is
applied.
All figures in this section indicate the pin positions when looking at the connector on the rear of
the QUBE Fiber Laser.
To operate this QUBE Fiber Laser the mains power connection and a control connection,
which can be digital (Ethernet, RS-232 or RS-485) must be made.
7.6.2 Connection Locations
All User connections are located at the rear panel of the QUBE Fiber Laser as shown in
Figure 13 (The cooling water manifold is not shown.) They are described in more detail in
Table 7.
To Next Page
Loading...