© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
Nonstandard sized
housing.
Not all combinations of options are available. Further information can be provided by request
from SPI Lasers.
6 Getting Started
6.1 Receiving and Inspection
Before installing or operating this QUBE Fiber Laser, you should:
Inspect the shipping container for damage
Inspect the QUBE Fiber Laser for signs of damage
Inspect the optical connector and conduit for any signs of damage
Confirm that the shipping carton contains all items on the shipping inventory list
including any accessories ordered as separate line items
Retain all packaging materials until the QUBE Fiber Laser has been commissioned. If
anything is missing or defective contact SPI Lasers. See Section 16 for contact details.
6.2 Unpacking and Handling
CAUTION: This QUBE Fiber Laser is heavy and so precautions
must be taken when lifting and moving.
Failure to do so may cause serious injury
This QUBE Fiber Laser is heavy. To avoid the risk of personal injury or damage to the QUBE
Fiber Laser when lifting or moving, lift only using the loops on the steel transport frame and
use a trolley or similar mechanical assistance when moving. Do NOT use the BDO fiber
termination block or the water manifold as lifting handles.
To Next Page
Loading...