© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
12.1.5 Fiber Zone Alarms
Fiber output housing over temperature
Power monitor signal out of range
Excessive peak back reflections detected
Excessive back reflections detected
12.1.6 Machine Interface Zone Alarms
Configuration memory failure, defaults loaded.
12.1.7 GUI Zone Alarms
Serial communications fault
12.1.8 Pump diode PSU Zone Alarms
Pump diode PSU 1 voltage dip detected
12.2 Warning Code Definitions
Each warning code contains information about the zone, and module associated with the
failure. It can be broken down as follows:
Warning Code = ZMNN
Where
Z is the zone associated with the warning as described in Table 3 above.
M is the module number to identify devices where there is more than one.
NN is the warning code identifying the problem.
To Next Page
Loading...