SPI Lasers redPOWER QUBE - Fiberview Installation; Table 6 Laser Integrator Supplied PC - for Operating Fiberview

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
39
7.5 FiberView Installation
Insert the medium supplied, which has the FiberView software on it, into the PC which will be
used to control the QUBE Fiber Laser. Run the setup.exe program. This will install FiberView
and necessary support programs.
Note: Check PC setting as follows: Control Panel – Regional & Language Options –
Advanced Tab – Language for non-Unicode Programs. Set this to English in drop down box.
Table 6 Laser Integrator Supplied PC – For Operating FiberView
Parameter
Requirement
Operating System:
Windows 7 and above
Minimum Hardware Specification:
Processor 1GHz
Hard drive with 250MB free space
2GB RAM
RS-232 Interface Port or RJ45 Network Port
Up to 57,600 Baud.
Minimum screen resolution 1024 x 768
Interconnect cable connections
RS-232:9-pin D-type, Null Modem
(Pins connected 2-3, 3-2, 5-5)
Ethernet: Cross-over cable for direct connection to
PC, Standard cable for LAN connection.
PC settings
Control Panel – Regional & Language
Options – Advanced Tab – Language
for non-Unicode Programs
English