SPI Lasers redPOWER QUBE - Labelling; Table 1 Safety, Explanatory and Compliance Labels

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
18
3.4.5 Europe: EMC Directive
This QUBE Fiber Laser falls outside the scope of the EMC Directive as it is intended
exclusively for an industrial assembly operation for incorporation into other apparatus.
However SPI Lasers recognises that Laser Integrators may require the integrated laser
system to comply with the directive. SPI Lasers has therefore designed for compliance to
parts of the standards listed below which are harmonised to the EMC Directive:
 BS EN 55011:2009+A1:2010.
3.4.6 USA: CFR Title 21 Part 1040, Food And Drug Administration
This QUBE Fiber Laser falls outside the scope of 21 CFR part 1040 as 21 CFR part 1040
does not apply to laser products which are sold to a manufacturer for use as components.
However SPI Lasers recognises that Laser Integrators may require the integrated laser
system to comply with the regulation. SPI Lasers has therefore demonstrated compliance to
parts of the European standard:
 IEC/EN 60825-1
Under Laser Notice 50, CDRH will not object to conformance with many sections of IEC
60825-1, as amended, as alternatives to comparable sections of 21 CFR §1040.10.
3.4.7 USA: CFR Title 47, Federal Communications Commission
This QUBE Fiber Laser is designed for compliance with:
 FCC CFR47: §15.107 Conducted emission limits
 FCC CFR47: §15.109 Radiated emission limits.
3.5 Labelling
Labels are placed on the top and rear panels of the QUBE Fiber Laser to warn of potential
hazards and to provide other useful information.
Table 1 to Table 2 below show the labels and give their locations.
Table 1 Safety, Explanatory and Compliance Labels
Rating plate label (Information may vary) (rear panel)