SPI Lasers redPOWER QUBE - Table 12 Laser Status Outputs

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
51
7.6.5.6 Status Outputs
Status outputs are provided at the Machine Interface. Connection details are shown in Figure
15. Table 12 shows the full list of functions that can be configured to apply to any of OUT0 -
OUT6 as shown in Table 10.
Table 12 Laser Status Outputs
ID
Output Function Description
Comments
0
Not supported
1
Laser STANDBY
False: QUBE Fiber Laser OFF or ON
True: QUBE Fiber Laser in STANDBY
2
Laser ON / Process Cycle Active
False: QUBE Fiber Laser OFF/STANDBY or
Process Cycle Stopped
True: QUBE Fiber Laser ON or Process Cycle
Running
3
Remote Control Status
False: LOCAL control Mode
True: Remote Control Mode
4
Sync
Synchronised True with duration of laser pulsing.
5
Process Cycle Wait
False: Process cycle running or in Autostep
mode.
True: Waiting for Process Cycle Step input
6
Processing Mode
False: Normal Mode
True: Process Cycles Mode
7
Alarm
False: Alarm not present
True: Alarm present
8
Warning
False: Warning not present
True: Warning present
9
Not supported
10
Acknowledge
False: Data not accepted or strobe off
True: Data accepted
11
Parameter Set / Process Cycle
Selected (Bit 0)
Provides monitor output to confirm parameter set
or process cycle selected
12
Parameter Set / Process Cycle
Selected (Bit 1)
13
Parameter Set / Process Cycle
Selected (Bit 2)