SPI Lasers redPOWER QUBE

To Next Page

To Previous Page

Commercial in Confidence

SM-S00500 Revision A 21 October 2016

redPOWER QUBE Cased Fiber Laser User Manual

Throughout the documentation, ‘WARNING’, and ‘CAUTION’ paragraphs appear. It is the

responsibility and duty of all Users who operate and maintain this equipment to fully

understand the WARNING and CAUTION and act in order to reduce or eliminate hazards.

3.2 Intended Use of the QUBE Fiber Laser

This QUBE Fiber Laser has been designed exclusively for incorporation or integration into

other equipment for processing:

 solid metals, including metal alloys and metal powders

 ceramics in both solid and powder form

 plastics

 composite materials

Operating the device within the limits of its designated use requires the user to:

 observe the instructions set out in this operating manual

 install and use this QUBE Fiber Laser in compliance with international, national and

local regulations regarding laser safety, for example IEC/EN 60825-1 and 21 CFR

1040.10.

 install and use this QUBE Fiber Laser in compliance with international, national and

local regulations regarding the safety of electrical equipment, for example BS EN

60204

 wire and connect the electrical lines to this QUBE Fiber Laser in compliance with

international, national and local regulations regarding electromagnetic compatibility

(EMC), for example the relevant sections of IEC/EN 61000 and FCC CFR47

 not move this QUBE Fiber Laser when it is switched on (except that the optical

connector may be moved provided that the bending limits of the conduit are observed)

 carry out necessary inspection and maintenance work

This QUBE Fiber Laser is not intended:

 for processing in connection with flammable or explosive materials

 for use in an explosion prone environment

SPI Lasers cannot be held liable for any damage resulting from such use. The risk lies entirely

with the User.

3.3 Hazards

3.3.1 Laser Hazards

All Warnings, including those in the Safety Notes and those in other sections of these

Instructions for Use, must be heeded.

SPI Lasers redPOWER QUBE - 3.3 Hazards