SPI Lasers redPOWER QUBE - Figure 35 Fiberview Parameter Editor

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
76
Figure 31 FiberView Parameter Editor
Use the up and down arrows by each parameter to adjust by amount shown as multiplier to
right of box.
To adjust the multiplier, right click on it and select desired value from the popup menu.
Alternatively, type the desired value directly into the appropriate parameter box.
9.3.2 Current Demand Level
 Mean Current Demand – used for CW and Sine Wave output styles. Maximum value is
100%.
 Peak Current Demand – used for Single Sector Pulse, Sine and User Defined Shape
output styles. Maximum value is 100%.
9.3.3 Frequency
Sets the pulse repetition frequency, in kHz, when operating in Internal Trigger mode. The
maximum frequency that can be set is 70kHz.
9.3.4 Width
Sets the pulse width, in microseconds, for the pulse width duration for the Single Sector Pulse
and User Defined Shape output styles. The maximum duration that can be set is 1s.