© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
QUBE Fiber Laser as used herein means the item that was
procured from SPI Lasers.
This QUBE Fiber Laser is a complete fiber laser system. By
‘complete’ it is meant a laser system as sold and ready for use for
its intended purpose without modifications to the specification of
the product.
This QUBE Fiber Laser is specifically designed to be a laser for
incorporation or integration into other equipment. As such, it does
not meet the full requirements for a stand-alone laser system as
defined by 21 CFR 1040.10 and IEC/EN 60825-1.
This QUBE Fiber Laser is not a consumer product and is not to be
sold on or made available as such.
Any person, company or organisation who integrates this QUBE
Fiber Laser into equipment, or any person, company or
organisation who uses this QUBE Fiber Laser in the form as
supplied by SPI Lasers.
A Laser Integrator is skilled in and understands the integration
issues surrounding the use, design and supply of laser products to
end users in the end markets which it supplies.
Individuals or organizations that use this QUBE Fiber Laser. User
includes the Laser Integrator and the end user
Those who have attended official Training Courses and have been
certified as competent.
3 Health and Safety
3.1 General
This section gives information on the hazards which may be encountered during installation,
operation and maintenance of this QUBE Fiber Laser and steps to reduce the risk. Also
included is information on laser and electrical safety compliance. All safety instructions,
including those in the Safety Notes and those in other sections of these Instructions for Use,
must be followed. Not following safety instructions may constitute a hazard to Users and third
parties or cause damage to property and the QUBE Fiber Laser.
Only Authorised Personnel who have been instructed in, and fully understand, the necessary
safety procedures should operate this QUBE Fiber Laser. Access must be restricted to
Authorised Personnel.
Any local safety requirements for the operation of this equipment must be complied with.
To Next Page
Loading...