SPI Lasers redPOWER QUBE - Page 117

© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
117
Code
Description
1152
Process cycle data reset
1153
Process cycles step data reset
12.2.3 Control Zone Warnings
Code
Description
2101
Ramp up incomplete
2102
Ramp down incomplete
2103
Ramp between parameters incomplete
2104
In safe mode following optical fault detection
2105
Modulation frequency error – Frequency demand out of range
2106
Fiber pierce frequency error – Frequency demand out of range
12.2.4 Fiber Zone Warnings
Code
Description
4m01
LPFL - Burn back protection disabled
HPFL - Main power monitor burn back protection disabled
4m02
FCMS circuit broken
4m03
Fiber output housing over temperature
4m04
Back reflection protection disabled
4m05
Excessive back reflections detected
12.2.5 Machine Interface Zone Alarms
Code
Description
5101
Using default Machine Interface configuration
12.2.6 PSU Zone Warnings
Code
Description
7150
PSU not present.
7151
PSU charge fault