© 2016 SPI Lasers UK Ltd.
Commercial in Confidence
SM-S00500 Revision A 21 October 2016
redPOWER QUBE Cased Fiber Laser User Manual
CAUTION: This QUBE Fiber Laser is designed to BS EN 60204-
1:2006+A1:2009 and must be grounded for safety and to comply
with regional electrical codes.
Failure to do so may result in electric shock and incorrect operation
of the QUBE Fiber Laser.
CAUTION: There is no Mains power isolation switch on this QUBE
Fiber Laser. The QUBE Fiber Laser should only be connected to a
switched electricity supply which can be isolated.
Weight Hazard Information
CAUTION: This QUBE Fiber Laser is heavy and so precautions
must be taken when lifting and moving.
Failure to do so may cause serious injury
Pressure Hazard Information
CAUTION: Ensure an approved overpressure safety device
compliant with ISO4126-1 (or equivalent) is installed when
connecting this QUBE Fiber Laser to an external chiller or factory
water supply.
Failure to do so may result in water leaks and damage to the QUBE
Fiber Laser and auxiliary equipment.
Laser for Incorporation
CAUTION: This PRISM Fiber Laser is specifically designed to be a
laser for incorporation or integration into other equipment. As such,
it is not required to, and does not, meet the requirements for a
stand-alone laser system as defined by IEC/EN 60825-1.
To Next Page
Loading...