5.2.3.14 Bridge mode
Indicates whether half-bridge or full-bridge mode is used for power transfer.
5.2.3.15 Message rate
The rate at which the power transmitter receives messages from the power receiver. A higher rate usually
indicates intense regulation or proprietary communication. Higher rate will also be observed during power transfer
initiation. A significantly low rate may indicate issues with in-band ASK communication. A rate of about 6-7
messages per second is standard during a stable power transfer operation.
5.2.3.16 Input power supply
Indicates a type of the available power source and which voltage and current levels it supports. The green dot
indicates the one currently in use.
5.2.4 Tx Information
Identifies the current hardware and firmware version.
Figure 22. Device information
5.2.5 Rx information
Basic information about the last identified power receiver.
Figure 23. Rx identification data
UM3286
Graphical user interface (GUI)
UM3286 - Rev 1
page 35/84
To Next Page
Loading...
