Stihl Cutquik TS 460 - Page 13

STIHL TS 460 13
Top: Top:
1 = Woodruff key Top: 1 = Rubber washer
2 = Washer Flat head screws 2 = Disk
Bottom: Bottom: Bottom:
Removing the shaft Removing the flange Removing the bearing
- Remove the woodruff key from - Unscrew both flat head screws - Remove the disk and rubber
- the groove in the shaft. - and remove them together with - washer from the flange and
- the spring washers. - guard.
- Remove the washer from the
- shaft.
Note: Note the number of spring
- Remove the bearing from the
washers. - guard.
- Draw the shaft out of the deep
- groove ball bearings. - Remove the flange from the
- guard.