STIHL TS 460 38
5.8 Engine Housing
Removing the engine
Top:
1 = Peg
2 = Choke lever
Bottom:
Removing the spark plug
terminal
Top:
1 = Short circuit wire
2 = Mounting screws
3 = Wire holder
Bottom:
Removing the ignition module
1 = Mount for ignition lead
- Lift engine out of engine
housing.
The parts are assembled in
reverse order.
Note: Tighten crankcase mounting
screws to 10 Nm.
Tighten mounting screws for
connecting piece to 10 Nm.
Tighten outer mounting screws of
muffler to 10 Nm
Fit choke shutter so that pin
engages choke lever.
Pull spark plug terminal out of
shroud opening before mounting
shroud.
- Remove engine, see 5.7.
- Disconnect short circuit wire from
connector on ignition module and
withdraw from wire holder.
- Remove ignition module
mounting screws. Remove
ignition module, disconnect
ignition lead from mounting.
To Next Page
Loading...
