Stihl Cutquik TS 460 - Slide Control; Contact Springs; Throttle Cable

STIHL TS 460 57
9.2 Slide Control 9.3 Contact Springs 9.4 Throttle Cable
- Remove throttle trigger, see 9.1.
- Remove slide control and
torsion spring from handle
grip.
- Insert longer, angled end of
torsion spring in slot in slide
control.
- Mount slide control and press
torsion spring into mount in
handle grip.
- Mount throttle trigger, see 9.1.
- Remove slide control, see 9.2.
- Unscrew contact spring
mounting screws, remove
contact springs.
- Insert contact springs.
- Screw in screws with short
circuit and ground wires and
tighten to 2.0 Nm
- Remove carburetor box cover,
see 10.3.
- Disconnect nipple of throttle
cable from slotted pin on
throttle lever.
- Remove mounting screw
of throttle cable.
Top:
Withdrawing the slide control
Bottom:
Properly positioned torsion spring
Top: Contact spring
mounting screws
Bottom:
Properly positioned contact springs
Top:
1 = Nipple of throttle cable
2 = Slotted pin
Bottom:
Throttle cable
mounting screw