Stihl Cutquik TS 460 - Fuel Tank Procedures

STIHL TS 460 73
10.8 Fuel Tank
Top:
Removing pickup body with assembly
hook 5910 893 8800
Bottom:
Pullin
g
p
icku
p
bod
y
off hose
Top:
Fuel Hose
Bottom:
Housing cover
mounting screws
Top:
Removing the fuel tank
Bottom:
Removing the rubber ring
Removing and refitting pickup
body:
- Use the special assembly
hook to pull the pickup body
out through the filler neck.
Note: During removal, make sure
that the fuel hose is not subjected
to too much stretching.
- Remove pickup body from
fuel hose and replace pickup
body.
The parts are assembled in
reverse order.
- Remove carburetor box cover,
see 10.2.
- Remove fuel hose from
connector on fuel tank.
- Unscrew filler cap and pull
ring out of fuel tank filler
opening.
- Unscrew housing cover
mounting screws, remove
housing cover.
- Remove fuel tank from engine
housing.
- Remove rubber ring from
threaded connector of fuel
tank.