Stihl Cutquik TS 460 - Page 74

STIHL TS 460 74
Top:
Removing the tank vent grommet
Bottom:
Removing the elbow
Top:
1 = Pickup body
2 = Hose
3 = Elbow
Bottom:
Grommet
Top:
Properly positioned elbow
a = 65°
Below:
Washers
- Remove grommet for the
connectors of the elbow.
- Remove elbow from grommet
and remove, together with
hose and pickup body, from
fuel tank.
- If necessary, remove hose
with pickup body from elbow.
- Remove grommet from fuel
tank.
- Remove washers from fuel
tank.
The parts are assembled in
reverse order.
Note: Position elbow as shown in
diagram.
Inspect washers on housing cover,
if necessary, glue new ones to the
places provided.
Tighten housing cover mounting
screws to 6.0 Nm.