Stihl Cutquik TS 460 - V-belt and Pulley System

STIHL TS 460 18
3.3
V
-belt
3.4
V
-belt Pulley
/
Clutch Drum
Top:
Removing the cover
Bottom:
Removing the V-belt
Top:
Assembly pin 1119 893 7200
Bottom:
Forcing out the needle sleeve
- Remove the V-belt, see 3.3.
- Remove the starter cup, see 7.7.
- Draw the V-belt pulley off the
crankshaft stub.
- Check the clutch drum: it must not
show any major signs of wear or
scoring. Replace the V-belt pulley if
necessar
y
.
- Remove the bearing with guard,
see 3.1.
- Remove the starter cover, see
7.2.
- Remove the cover.
- Remove the V-belt from the
V-belt pulley.
The parts are assembled in
reverse order.
- Check the needle sleeve and
force it off the V-belt pulley
from the clutch side using an
assembly pin if necessary.
Top:
Removing the V-belt pulley
Bottom:
Friction surface of the clutch drum