STIHL TS 460 48
Top:
Short circuit wire and ground
wire in the slot of the connecting
piece
Bottom:
1 = Peg
2 = Grommet
3 = Locating Slot
6.1.5 Flywheel
Top:
Shroud mounting screws
(the screws on the right are hidden)
1 = Spark plug terminal
Bottom:
Locking strip 4221 893 5900
Top:
Locking strip in the cylinder
Bottom:
Fan cover mounting screws
Fit short circuit wire and ground
wire in the slot in the
connecting piece.
Fit short circuit wire in the area
of the expansion tank into the
locating slot.
Press grommet into mounting
and lay short circuit wire behind
pin.
Removing the flywheel:
- Remove spark plug terminal
from spark plug.
- Remove shroud mounting
screws. Remove shroud,
pressing the spark plug
terminal out of the opening in
the shroud.
- Remove spark plugs and
replace with locking strip in
cylinder to block crankshaft.
- Take out the fan cover mounting
screws and remove the fan
cover.
To Next Page
Loading...
