Stihl Cutquik TS 460 - Handle Bar and Tube Bracket

STIHL TS 460 58
9.6 Handle Tube Bracket
9.5 Handle Ba
r
Throttle Cable in handle grip
- Remove throttle trigger, see 9.1.
- Remove throttle cable from
mount in handle grip.
The parts are assembled in
reverse order.
- Unscrew handle bar mounting
screws from handle grip and
handle tube bracket.
- Unscrew handle bar mounting
screws from handle tube bracket,
remove handle bar.
- Mount handle bar, screw in
screws and tighten to 8.0 Nm.
- Remove handle bar, see 9.5
- Unscrew support mounting
screws, remove support.
- Pry stopper out of annular
buffer.
Top:
Handle bar mounting screws
(right)
Bottom
Handle bar mounting screws
(left)
Top:
Support mounting
screws
Bottom:
Prying out the stopper