Stihl Cutquik TS 460 - Carburetor Removal and Installation

STIHL TS 460 63
10.3 Removing and Installing
the carburetor
Carburetor box cover
fastening screws
Top:
Removing the grommet
Bottom:
1 = Nipple of throttle cable
2 = Slotted pin
Top:
Throttle cable
mounting screw
Bottom:
Clamp on manifold
The all-position diphragm
carburetor consists of a fuel
pump and the actual carburetor.
Although the fuel pump shares a
common housing with the
carburetor, it operates as a
completely separate and
independent unit.
Troubleshooting chart - see 2.5.
- Unscrew carburetor box
mounting screws, remove
carburetor box cover.
- Remove grommet from mount
in engine housing.
- Detach nipple of throttle cable
from slotted pin at throttle
lever.
- Unscrew throttle cable
mounting screw and press
throttle cable to the side out of
the machine.
- Loosen screws on manifold
clamp and remove manifold
from connector.