Stihl Cutquik TS 460 - Clutch Assembly and Installation

STIHL TS 460 21
4.2 Assembly and Installation
- Slide cover washer onto
crankshaft stub with convex side
facing outward.
- Screw clutch onto crankshaft
and torque down to 40 Nm.
- Fit V-belt pulley, see 3.4.
- Fit the retainers onto the
clutch shoes.
- Fit the clutch shoes over the
arms of the clutch carrier so that
the series number, e.g. 1122a,
is on the same side as the
carrier’s hexagon.
- Clamp the clutch, e. g. one of the
shoes, in a vise.
- Attach one end of each spring
to the clutch shoes by hand.
- Use the other assembly hook to
attach the other ends of the
springs and press them firmly
into the clutch shoes with one
finger.
Top:
Fitting retainer on
clutch shoe
Bottom:
Pushing clutch shoe
onto carrier
Top:
Clutch clamped in a vise
Bottom:
Attaching clutch springs
Tightening the clutch