Stihl Cutquik TS 460 - Engine Removal and Installation

STIHL TS 460 35
5.7 Engine Removal and
Installation
Top:
Jaws 0000 893 3706
(with profile 3.1 and 4)
Bottom:
Removing the oil seal
Pressing in the oil seal
with press sleeve
Shroud mounting screws (the two
screws on the right side are hidden)
1 = Spark plug terminal
Note: When using the puller, make
sure that it does not damage the
crankshaft surface, especially in the
area of the oil seal.
- Clean sealing surface with
standard commercial
solvent-based degreasant
containing no chlorinated or
halogenated hydrocarbons,
see 11.2.
- Fill space between sealing
lip and dust lip with
lubricating grease, see 11.2.
- Apply a thin coating of sealant
to outer circumference of oil
seal, see 11.2
- Slide oil seal over crankshaft
stub with open side facing
crankcase and press it in with
the press sleeve.
- Wait approximately one
minute, then turn over
crankshaft several times.
- Install flywheel, see 6.1.5.
The engine can be removed from
the engine housing without having
to remove the carburetor and
muffler.
- Remove V-belt, see 3.3.
- Unplug spark plug terminal from
spark plug.
- Remove hood mounting screws.
Remove hood, press spark plug
terminal out of the hood opening.
Ignition side:
- Remove flywheel, see 6.1.5.
- Install jaws with profile 3.1 at
the pulley.
- Attach the pulley and pull out
the oil seal.