Stihl Cutquik TS 460 - Page 25

STIHL TS 460 25
Top:
1 = Flat face on tool's shank
2 = Pin
Bottom
Pressing in the installing tool until the
sleeve butts against the tool's shoulder
Slipping sleeve on to othe
r
end of the shank
Top: Inserting
snap ring in
piston boss
Bottom:
Fitting cylinder gasket
1 = Slot
- Remove the sleeve and slip it
onto the other end of the
shank.
Note: Inner pin must again point
toward flat face of tool's shank.
- Apply installing tool to the
piston boss (flat face on shank
must point toward piston
head), hold the piston steady,
center the tool shank exactly
and press home until the snap
ring slips into the groove.
Note: Fit the snap ring so that its
gap is on the pistons vertical axis
(it must point either up or down).
- Repeat the above procedure to fit
the other snap ring.
- Fit new cylinder gasket to
crankcase so that slot in gasket
is positioned over slot in
crankcase.
- Push the large slotted
diameter of the sleeve over the
magnet and snap ring. Position
the sleeve so that the inner pin
points toward flat face of tool's
shank.
- Stand the installing tool,
sleeve downward, on a flat
surface (wooden board)
and press vertically
downwards until the sleeve
butts against the tool's
s
h
ou
l
de
r.