Stihl Cutquik TS 460 - Page 76

STIHL TS 460 76
Top:
Cap
Bottom:
Removing the valve
Top:
Removing connecting
piece
Bottom:
Vent insert
Top:
Mounted vent insert
a = approx. 6 mm
Bottom:
Mounted vent hose
a = approx. 140 mm
- Press cap off of tank vent.
- Remove valve from tank vent.
- Detach throttle cable from
carburetor, see 9.4, and lay
aside.
- Remove AV-molding, see 9.7.
- Remove short circuit wire and
ground wire from slot in
connecting piece and lay aside.
- Push handle grip somewhat to
the side and pull out connecting
piece.
- Unscrew vent insert from
connecting piece.
- Wash all parts in clean white
spirit and blow through
thoroughly with pressurized air.
The parts are assembled in
reverse order.
Note: Screw in vent insert to a
depth of approx. 6 mm.
Pull vent hose into tank until it
extends approx. 140 mm out of
hole on the side.
Caution: Press connecting piece
in carefully, so that connector does
not break off in grommet during
assembly.