20 3006 -109-101 REV A www.stryker.com
Return To Table of Contents
OPERATING I.V. POLES
WARNING
To avoid pinching your fingers, place the I.V. pole in the upright position
before using the drive handle.
To use the “Removable” I.V. pole:
1. Install the pole at any of the four receptacles on the bed top (located
on all four corners of the frame).
2. To raise the height of the pole, turn knob (A) counterclockwise and
pull up on the telescoping portion (B) of the pole and raise it to the
desired height.
3. Turn knob (A) clockwise to tighten the telescoping portion in place.
CAUTION
The maximum safe working load for each I.V. pole is 40 pounds.
To use the 2-Stage Permanently Attached I.V. pole:
Note
The 2-stage permanently attached I.V. pole is an option and may have been
installed at either the head, foot or both ends of the bed. The choice was made
at the time the unit was purchased.
1. Lift and pivot the pole from the storage position and push down until it
rests in the receptacle.
2. To raise the height of the pole, pull up on the telescoping portion (A) until
it locks into place at its fully raised position.
3. Rotate the I.V. hangers (B) to desired position and hang I.V. bags.
4. To lower the I.V. pole turn the latch (C) clockwise until section (A) lowers.
CAUTION
The maximum safe working load for each I.V. pole is 40 pounds.
A
C
B
Litter Operation Guide
To Next Page
Loading...
