www.stryker.com 6390-009-002 REV D 11
Introduction
Specifications (Continued)
CAUTION (CONTINUED)
• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area (for which CISPR 11 class B is normally required) is likely to cause harmful
interference, in which case the user will be required to correct the interference at their expense. In the event of
interference, please relocate or reorient the Power-LOAD system or interfering product.
Notes
• This device is compliant to European Directive 2011/65/EU Restriction of Hazardous Substances (RoHS) as it does
not contain any of the restricted substances in excess of the acceptable threshold in electrical and electronic
equipment.
• This device is considered an "article" as defined in Article 3(3) of the European Registration, Evaluation,
Authorization, and restriction of Chemicals (REACH) Regulation (EC) 1907/2006, and it does not release
substances under its normal use. Suppliers of articles are not required to register with the European Chemicals
Agency (ECHA), but must provide recipients with information on Substances of Very High Concern (SVHC) if those
are present above a concentration limit of 0.1 % weight on an article level. Based on a diligent review of information
provided by our suppliers, this device does not contain above 0.1 % weight (w/w) threshold of any (SVHC) as listed
by the ECHA as of the 30MAR2010 release. Stryker will continue to monitor REACH regulations for any SVHC that
may be included in subsequent ECHA candidate lists and will communicate this information to customers.
Standards with required options
To be compliant with the standards, you must use Power-LOAD with the following compatible cots. See the Operations
Manual for your cot model for more information.
Note: Compatible cot is loaded into Power-LOAD in powered mode for crash testing.
Standard Power-LOAD compatible cot models
SAE J3027 and AS/NZS-4535:1999
6500, 6506
BS EN 1789:2007
6500, 6506, 6085, 6086
To Next Page
Loading...
Need help?
General
