8 SM-7100 REV 01 www.stryker.com
Introduction
Specifications (Continued)
Specifications listed are approximate and may vary slightly from product to product or by power supply fluctuations.
Stryker reserves the right to change specifications without notice.
Standards applied
IEC 60601-1:2005+CORR 1 (2006) + CORR 2 (2007)
Medical electrical equipment - Part 1: General requirements
for basic safety and essential performance
IEC 60601-1-2:2007
Medical electrical equipment - Part 1-2: General
requirements for basic safety and essential performance -
Collateral standard: Electromagnetic compatibility -
Requirements and tests
IEC 60601-2-52:2009
Medical electrical equipment - Part 2-52: Particular
requirements for the basic safety and essential performance
of medical beds
IEC 60601-2-54:2009*
*Only applicable when the product is equipped with
the radiolucent backrest option
Medical electrical equipment - Part 2-54: Particular
requirements for the basic safety and essential performance
of X-ray equipment for radiography and radioscopy
WARNING
Only use the input voltage and frequency as rated on the product.
CAUTION
• To minimize the risk of any electromagnetic interference, the product design follows the standard IEC 60601-1-2.
To avoid problems, use the bed in accordance with the EMC/EMI requirements in the EMC section of this
operations manual.
• Portable and mobile RF communications equipment can produce electromagnetic interference with SV1. To prevent
interference caused by portable and mobile RF communications equipment, maintain a minimum distance between
portable and mobile communications equipment and SV1 according to the EMC section of this operations manual.
To Next Page
Loading...
Need help?
General
