ME(H4SO)-40
MECHANICAL
Engine Assembly
14) Connect the following hoses.
(1) Fuel delivery hose, return hose and evapo-
ration hose
(2) Heater inlet and outlet hoses
(3) Brake booster vacuum hose
15) Connect the following connectors.
(1) Engine ground cables
Tightening torque:
14 N·m (1.4 kgf-m, 10.1 ft-lb)
(2) Engine harness connectors
(3) Generator connector and terminal
(4) A/C compressor connectors
16) Connect the following cables.
(1) Accelerator cable
(2) Cruise control cable (Model with cruise con-
trol)
17) Adjust each connected cable.
18) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
19) Install the A/C pressure hoses.
<Ref. to AC-36, INSTALLATION, Hose and Tube.>
20) Install the radiator to vehicle. <Ref. to
CO(H4SO)-20, INSTALLATION, Radiator.>
21) Install the air intake duct and air cleaner case.
<Ref. to IN(H4SO)-6, INSTALLATION, Air Intake
Duct.> and <Ref. to IN(H4SO)-5, INSTALLATION,
Air Cleaner Case.>
22) Install the under cover.
23) Install battery in the vehicle, and then connect
the cables.
24) Fill engine coolant.
<Ref. to CO(H4SO)-13, FILLING OF ENGINE
COOLANT, REPLACEMENT, Engine Coolant.>
25) Check the ATF level and correct if necessary.
(AT model)
<Ref. to 4AT-31, INSPECTION, Automatic Trans-
mission Fluid.>
26) Charge the A/C system with refrigerant.
<Ref. to AC-22, OPERATION, Refrigerant Charg-
ing Procedure.>
27) Remove the front hood stay, and then close the
front hood.
28) Take off the vehicle from lift arms.
C: INSPECTION
1) Make sure the pipes and hoses are installed cor-
rectly.
2) Make sure the engine coolant and ATF are at
specified levels.
To Next Page
Loading...
