FU(H4SO)-33
FUEL INJECTION (FUEL SYSTEMS)
Manifold Absolute Pressure Sensor
9. Manifold Absolute Pressure
Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from manifold abso-
lute pressure sensor.
3) Remove the manifold absolute pressure sensor.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• For tightening torque, refer to “COMPONENT”.
<Ref. to FU(H4SO)-3, COMPONENT, General De-
scription.>
• Replace the O-ring with a new one.
FU-00009
FU-00294
FU-00295
FU-00296
To Next Page
Loading...
