ME(H4SO)-46
MECHANICAL
Crankshaft Pulley
Tightening torque:
177 N·m (18.0 kgf-m, 130.2 ft-lb)
3) Confirm that the tightening angle of crankshaft
pulley bolt is 65 degrees or more. If the tightening
angle of crankshaft pulley bolt is less than 65 de-
grees, conduct the following procedures.
(1) Replace the crankshaft pulley bolts and
clean them.
Crankshaft pulley bolt:
12369AA011
(2) Clean the crankshaft thread using an air
gun.
(3) Apply engine oil to the crankshaft pulley bolt
seal and thread.
(4) Tighten the bolts temporarily with tightening
torque of 44 N·m (4.5 kgf-m, 33 ft-lb).
(5) Tighten the crankshaft pulley bolts keeping
them in an angle between 65 degrees and 75
degrees.
NOTE:
Conduct the tightening procedures by confirming
the turning angle of crankshaft pulley bolt referring
to the gauge indicated on timing belt cover.
4) Install the A/C belt tensioner.
5) Install the V-belt. <Ref. to ME(H4SO)-43, IN-
STALLATION, V-belt.>
C: INSPECTION
1) Make sure the V-belt is not worn or otherwise
damaged.
2) Check the tension of the belt. <Ref. to
ME(H4SO)-44, INSPECTION, V-belt.>
ME-00227
STST
ME-00225
To Next Page
Loading...
