CO(H4SO)-21
COOLING
Radiator
11) Connect the radiator outlet hose.
12) Connect the connectors to radiator main fan
motor (A) and sub fan motor (B).
13) Install the under cover.
14) Lower the vehicle.
15) Connect the battery ground cable to battery.
16) Fill engine coolant. <Ref. to CO(H4SO)-13,
FILLING OF ENGINE COOLANT, REPLACE-
MENT, Engine Coolant.>
17) Check the ATF level. <Ref. to 4AT-31, IN-
SPECTION, Automatic Transmission Fluid.>
C: INSPECTION
1) Remove the radiator cap, top off radiator, and
then attach the tester to radiator in place of cap.
2) Apply a pressure of 157 kPa (1.6 kg/cm
2
, 23 psi)
to the radiator to check if:
(1) Engine coolant leaks at/around radiator.
(2) Engine coolant leaks at/around hoses or
connections.
CAUTION:
• Engine should be turned off.
• Wipe engine coolant from check points in ad-
vance.
• Be careful to prevent engine coolant from
spurting out when removing the tester.
• Be careful also not to deform the filler neck of
radiator when installing or removing tester.
CO-00076
(A)
CO-00224
CO-00225
(B)
FU-00009
CO-00094
To Next Page
Loading...
