EN(H4SO)(diag)-28
ENGINE (DIAGNOSTICS)
Data Link Connector
8. Data Link Connector
A: NOTE
This connector is used both for OBD-II general scan tools and the Subaru Select Monitor.
CAUTION:
Do not connect any scan tools other than the OBD-II general scan tools and the Subaru Select Mon-
itor, because the circuit for the Subaru Select Monitor may be damaged.
EN-00037
12345 768
910111213 1514 16
Terminal No. Contents Terminal No. Contents
1 Power supply 9 Blank
2 Blank 10 Subaru Select Monitor signal
3 Blank 11 Blank
4 Blank 12 Ground
5 Blank 13 Ground
6 Test mode check signal 1 14 Blank
7 Blank 15 Blank
8 Blank 16 Blank
To Next Page
Loading...
