FU(H4SOw/oOBD)-30
FUEL INJECTION (FUEL SYSTEMS)
Camshaft Position Sensor
6. Camshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from camshaft posi-
tion sensor.
3) Remove the bolt which installs the camshaft po-
sition sensor to camshaft position sensor support.
4) Remove the bolt which installs the camshaft po-
sition sensor support to camshaft cap LH.
5) Remove the camshaft position sensor and cam-
shaft position sensor support as a unit.
6) Remove the camshaft position sensor itself.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
For tightening torque, refer to “COMPONENT”.
<Ref. to FU(H4SOw/oOBD)-3, COMPONENT,
General Description.>
FU-00009
FU-00147
FU-00177
FU-00178
FU-00179
To Next Page
